CABLE CONFIGURATION SETUP, FOR THE FASTWIRE 2 PROGRAM.

 Here is a list of the pinouts, that need to be rolled
 over,  to get the  parallel  cable  to work  properly.


PARALLEL: Setting up the cable as parallel.

  Needs to be a (DB 25 pin male connector) parallel on both ends, not to
  exceed 15 feet without a special amplifier for high frequency circuits!

        2 ¯------------> 15     All these pins need to be rolled over
       15 <------------®  2     to meet the pins on the other side!
        3 ¯------------> 13
       13 <------------®  3
        4 ¯------------> 12
       12 <------------®  4
        5 ¯------------> 10
       10 <------------®  5
        6 ¯------------> 11
       11 <------------®  6



SERIAL: Just about any null modem configuration will work.  Just ask
        a local computer store for information about buying a null
        modem adapter.  They usually run about $5.øø

   Here is the 25 pin to 25 pin null modem adapter that I used.

          1 ®-------------¯ 1       Pin 1 goes to 1.
TX        2 ¯-------------> 3       Pin 2 rolls over to 3 on both ends.
RX        3 <-------------® 2
DSR   |---6                 6---|   On each side, pins 6, 8 & 22 are tied
S GND |   7 ®-------------¯ 7   |   together.  Pin 7 goes to pin 7.
CD    |---8 ¯-------------> 20  |
DTR   |  20 <-------------® 8---|
RI    |--22                 22--|