IDE/AT INSTALLATION INSTRUCTIONS

   Conner drives are low level formatted at the factory.  It is only
   necessary to run SETUP..FDISK..and DOS FORMAT.

   Drive jumper settings:
   Single drive = jumper ACT and C/D
   Master drive = jumper ACT, C/D and DSP
   Slave  drive = remove all jumpers

   Model CP3204 jumper settings:
   Single drive = jumper E-2
   Two Drives:
   Master drive = jumper E-1 and E-2
   Slave drive  = remove all jumpers

   Conner drives operate in a translate mode as the native parameters
   do not match the BIOS drive types.

 Model   Hds   Cyls   Sec  Pcomp  L-zone   Drive Type  Formatted Capacity

 CP2022   2    653    32     0      653       2             21.4  Mb
 CP2024   2    653    32     0      653       2             21.4  Mb
 CP3024   2    636    33     0      636       2             21.5  Mb
 CP4024   2    627    34     0      627       2             21.83 Mb

 CP 344   4    805    26     0      805      17             42.87 Mb
 CP3044   2   1047    40     0     1047      17             42.89 Mb
 CP4044   2   1105    38     0     1105      17             43.0  Mb

 CP3104   8    776    33     0      776      *UT           104.9  Mb
 CP3114   8    832    33     0      832      *UT           112.46 Mb
 CP3184   6    832    33     0      832      *UT            84.34 Mb
CP30104   4   1522    39     0     1522      *UT           121.57 Mb
 CP3204  16    683    38     0      683      *UT           212.62 Mb


 *UT = Universal translate.  Select a drive type that is close  to
 the size in megabytes, but does not exceed the  capacity  of  the
 drive.  AMI BIOS allows type 47 to punch in the drive information
 of the exact drive type. The other BIOS's should soon follow suit.

    J-4 LED:
      Pin 1 = +5VDC
      Pin 2 = Ground

 Conner host adapter jumper configuration:

   E-1 open,  E-2 jumpered  and E-4 jumper center pin to E-4.


       CONTACT YOUR LOCAL DISTRIBUTOR FOR TECHNICAL ASSISTANCE